Used to break loose the supply line, angle stop, and closet nuts without stripping the fittings. We carry two sizes so we are not forcing a wrench that does not fit.
Toilet Installation New Braunfels TX done right the first time
When you need toilet installation New Braunfels TX homeowners can count on, our team handles everything from hauling off the old bowl to setting a new wax ring and testing for leaks.
Serving new braunfels and nearby areas.
How big is the job?
Flange repair
Cracked or low flange needs repair before the new toilet is set.
- 1. Simple swap Standard toilet replacement with a sound flange and accessible shut-off.
- 2. Flange repair Cracked or low flange needs repair before the new toilet is set.
- 3. Full refit Floor damage, electrical work, or commercial fixtures planned in writing first.
Drag the needle to compareTouch and drag the needle
- 30Services from one local team
- 20Areas served around new braunfels
- Flange firstWe check the flange before setting the bowl
- Two flushesWe test the base and supply before we leave
What Our Toilet Installation Service Includes
Every install includes the labor, the wax ring, the supply line, and the haul-away. The toilet itself is separate unless you ask us to source it.
Work order
Toilet Installation- Old Toilet Removal: We shut off the water, drain the tank and bowl, disconnect the supply line, and lift the old unit out. The old wax gets scraped off the flange, and the old toilet goes on our truck. You do not have to figure out what to do with it.
- New Wax Ring and Hardware: A fresh wax ring, closet bolts, washers, and nuts are included. We also bring a new supply line and Teflon tape. These are the parts that fail most often on a reinstall, and replacing them is cheap insurance against a leak.
- Flange Inspection and Repair: We check the closet flange for cracks, corrosion, or a height that sits below the finished floor. If it is damaged, we repair or replace it.
- Level Set and Shim: The bowl gets shimmed level and the closet bolts are snugged in a crisscross pattern so the porcelain does not crack. A toilet that rocks will eventually break the wax seal, so we make sure it sits flat and stays flat.
- Two Full Flush Test: We fill the tank, run two complete flush cycles, and check the base, the supply connection, and the tank bolts for any sign of seepage. If something drips, we fix it before we pack up. You get a working toilet, not a callback.
- Cleanup and Haul-Away: Drop cloths come up, the bowl gets wiped down, and the old unit leaves with us.
What the first visit covers
First visit
We inspect the flange, measure the rough-in, and confirm the fixture and parts needed for the install.
Toilet installation at your home
We handle standard swaps, comfort height upgrades, and bidet installs in New Braunfels homes.
Standard replacement
Old toilet out, new one set and tested.
Comfort height upgrade
Easier on knees and hips, set level and sealed.
Bidet toilet install
Including outlet work if the model needs it.
Flange repair
Cracked or low flange fixed before the new bowl goes down.
Toilet installation at your business
We install and replace toilets in New Braunfels commercial restrooms with minimal downtime.
Restaurant restrooms
High-traffic fixtures installed to code.
Office and retail
ADA height and flush volume handled correctly.
Rental properties
Multiple units done in a single scheduled visit.
Toilet Installation New Braunfels TX: What the Job Actually Involves
A toilet is a heavy fixture sitting on a wax seal. Set it wrong and you get a slow leak that rots the floor. We do the flange work, set it level, and test it before we leave.
We cut the water, drain the tank and bowl, pull the old unit, scrape the old wax, and inspect the flange for cracks or rot. Then we set the new bowl level, torque the closet bolts, reconnect the supply, and run two full flush cycles before we call it done.
Most New Braunfels homes we service were built between the 1970s and the 2010s, and original toilets in those houses are 1.6-gallon models that have long since lost their flush. Hard Hill Country water leaves mineral scale inside the trapway and jets, so the bowl never fully clears. If you have been searching for toilet replacement New Braunfels Texas near me, the fix is usually a new WaterSense-labeled unit that uses 1.28 gallons or less per flush.
- What it is
- Removing an old toilet and setting a new one to code.
- When it helps
- Rocking, leaking at the base, or a flush that no longer clears.
- What you get
- A level, sealed, tested toilet and the old unit hauled off.
How Our Toilet Installation Process Works
Five steps, start to finish. Most standard swaps take 60 to 90 minutes on site. Here is exactly what happens when we show up.
Tools and Methods We Use on Every Install
Each method answers a different question. Together they leave very little to guess.
Removes old wax from the flange and the bowl horn. A clean flange surface is what lets the new wax ring seal properly. Skipping this step is how leaks start.
The bowl has to sit level or it will rock and break the wax seal. We use composite shims that will not rot, and we check level front to back and side to side.
When a toilet backs up repeatedly, we run a camera down the line to see if the problem is the fixture or the drain. It saves you from buying a new toilet that will not fix the issue.
We use RIDGID inspection equipment and Milwaukee cordless tools on the truck. They hold up to daily use and let us diagnose and repair without running back to the shop for parts.
When New Braunfels Customers Call Us
A guest bathroom toilet fails the morning of a family gathering in Gruene.
We prioritize same-day calls when we can.
HomesA homeowner in Vintage Oaks wants to upgrade to a comfort height or bidet toilet.
We help you pick the right model, confirm the rough-in measurement, and handle the install.
HomesA property manager in Creekside needs toilets replaced between tenants.
We schedule the work around your turnover window, install standard or commercial-grade fixtures, and haul the old units off.
BusinessesA restaurant near Downtown New Braunfels has a restroom toilet that will not stop running.
We treat commercial restroom issues as priority work.
Businesses
How Toilet Installation Works in New Braunfels
New Braunfels sits on the edge of the Hill Country, and the water here is hard. That mineral content leaves scale inside toilet trapways and jets, which is why so many older toilets in this area flush weak even after you replace the flapper.
Gruene
Many homes here are older with original cast iron flanges. We check for corrosion and replace the flange if it is too far gone to hold a wax seal.
Vintage Oaks
Newer construction with PVC flanges set in tile. We verify the flange height matches the finished floor before setting the bowl.
Veramendi
Tight hall bathrooms are common here, which makes getting a level set on the bowl more important. We shim carefully to avoid rocking.
- Gruene
- Vintage Oaks
- Veramendi
- Creekside
- Downtown New Braunfels
From problem to finished result.
Slide to compare the photo with an illustrative inspection view. It is generated from the photo, not a measurement.
PhotoRocking Toilet in Gruene Fixed
Before: A homeowner in Gruene had a toilet that had been rocking for months. The wax ring had failed, and water was seeping under the tile every time someone flushed. The flange was cracked from soil movement.
After: We replaced the cast iron flange with a new PVC flange, set a comfort height Kohler toilet with a fresh wax ring, and shimmed it level. Two full flushes, no leaks. The floor has stayed dry since.
Bidet Toilet Upgrade in Veramendi
Before: A couple in Veramendi bought a bidet toilet online but did not have a GFCI outlet near the fixture. They had been using an extension cord, which is not safe in a bathroom. The old toilet was a 1.6-gallon model with a weak flush.
After: We ran a GFCI outlet to code, installed the bidet toilet, and set it level with a new wax ring. The new unit uses 1.28 gallons per flush. They now have a working bidet with no extension cord.
Commercial Restroom Refit in Creekside
Before: A property manager in Creekside had three rental units with toilets that ran constantly and would not flush fully. Tenants were complaining about water bills and repeated clogs. Two of the three toilets had original 1990s fixtures.
After: We replaced all three toilets with WaterSense models, set new wax rings, and replaced the supply lines and shut-off valves. Each unit was done in under two hours. The running water stopped and the clog complaints went away.
Toilet Problems We Fix With a New Install
Some toilet issues are worth repairing. Others mean it is time for a new fixture. Here are the problems that usually point toward replacement.
Toilet rocks or shifts when you sit down
A rocking toilet breaks the wax seal and lets sewer gas and water seep under the floor.
Water pools around the base after every flush
That puddle is a failed wax ring or a cracked bowl. It soaks into the subfloor, damages tile, and can rot the floor joists underneath.
Toilet runs constantly or will not flush fully
A running toilet can waste 200 gallons a day and add real money to your water bill.
Repeated clogs no matter what you do
If you are plunging every week, the problem may be the toilet itself or the drain line downstream.
Why Homeowners Choose a Pro Install
A toilet is a 60 to 100 pound fixture sitting on a wax seal.
No More Phantom Leaks
A wax ring that is compressed unevenly or a flange that sits below the finished floor will seep every flush.
Lower Water Bills
A worn flapper on an old toilet can waste 200 gallons a day. Swapping to a WaterSense model cuts usage to 1.
Comfort Height and Bidet Options
Comfort height toilet installation New Braunfels homeowners ask for sits about 17 to 19 inches from floor to rim, which is easier on knees…
One Trip, Old Unit Hauled Off
We bring the new toilet, the wax ring, the supply line, and the Teflon tape. When we leave, the old unit goes with us.
What you receive on install day
Clear records you can keep and share.
Model info
The make and model of the toilet we installed.
Flush rating
The gallons-per-flush rating for your records.
16 Years of Toilet Work in Comal County
Comal Crest Plumbing has been installing toilets in New Braunfels since 2010.
Flange height
We measure where the flange sits relative to the finished floor. If it is low, the wax ring will not seal.
Rough-in measurement
We check the distance from the wall to the closet bolts. That tells us which toilet models will fit.
Shut-off condition
We test the angle stop before we start. A seized valve needs replacing before the old toilet comes out.
Is your New Braunfels area covered?
Type your ZIP code or town. If you are outside the list, call and ask.
new braunfels ZIP codes
- 78132
- 78130
- 78131
- 78135
Towns we serve.
Based in new braunfels and covering the places around it. Pick one for local details.
What New Braunfels Customers Say
Our upstairs toilet had been rocking for months and I kept putting it off. Comal Crest came out, found the flange was cracked, repaired it, and set a new comfort height Kohler. They were in and out in about two hours and the floor has been dry ever since. Fair price, no upsell.
I bought a bidet toilet online and had no idea it needed a GFCI outlet nearby. The technician explained what was needed, ran the outlet, and installed the unit the same visit. He tested everything twice before he left. I appreciated that he did not just install it and leave me with a problem.
We manage several rental units in New Braunfels and use Comal Crest for toilet replacements between tenants. They show up when scheduled, the work is clean, and they haul the old units off. Having one reliable company for this saves me a lot of phone calls.
Frequently Asked Questions About Toilet Installation
Short answers for the first few minutes. The team can cover the rest.
Still have a question?
Describe what you are seeing and we will point you to the right next step.
(737) 707-1110If we find a broken flange or a rotted subfloor, that adds to the job. You get the full number before we start.
We handle the flange, wax ring, supply line, and shut-off valve, and we haul the old unit away when we leave.
A standard swap takes 60 to 90 minutes on site. If the flange is cracked, the shut-off valve is seized, or the floor needs repair, plan on two to three hours. We schedule a window, not an all-day visit, and we call ahead when we are on the way so you are not waiting around.
Yes. Plenty of customers pick up a Kohler or American Standard unit at a local store and have us set it. We will confirm the rough-in measurement matches your existing flange before we start, and we bring the wax ring, supply line, and closet bolts. Just have the box in the bathroom when we arrive.
Other Services We Handle
Other services from the same team.
Need Toilet Installation New Braunfels TX? Call Today
(737) 707-1110We install toilets across New Braunfels and Comal County, usually in a single visit. You get a price before we start, a clean install, and the old unit hauled off.
Call Comal Crest Plumbing
Reach us at (737) 707-1110 any time, day or night. For standard repairs we book same-day slots and call ahead with a real arrival window. For emergencies, we dispatch immediately. You can also email [email protected] and we will get back to you the same business day.